Optical Fibre Probes - analog

Voltage measurement via optical fibre
Non-interactive monitoring of operating voltages and operating points of analogue circuit elements (EUT monitoring) is of essential importance for EMC analysis of subassemblies and devices under the influence of RF, burst and ESD.
A measuring system consisting of a small sensor with serial ADC, which is fed via the EUT's power supply and the conversion result of which is coupled out via synthetic optical fibre, guarantees non-interactive monitoring. An optical receiver with a serial DAC converts the digitally transmitted signal into analogue voltage values which can be evaluated at an oscilloscope or voltage meter.

Set A 100-1 / Set A 100-2

: A 100-1 set

Contents A 100-1:	Contents A 100-2:
1 Optical receiver (DAC) AE 100	2 Optical receivers (DAC) AE 100
1 Analog sensor (ADC) AS 1xx	2 Analog sensors (ADC) AS 1xx
1 AC mains adapter 12 V / 300 mA	1 AC mains adapter 12 V / 300 mA
1 Optical fibre 1,5 m	2 Optical fibre 6 m
Case 175 x 125 x 30 mm	1 Connecting cable 18 cm
Accessories	Case 338 x 2260 x 57 mm
Instruction	Accessories
	Instruction
Technical data	Technical data

Set A 200-1 / Set A 200-2

Contents A 200-1:	Contents A 200-2:
1 Optical receiver (DAC) AE 200	2 Optical receivers (DAC) AE 200
1 Analog sensor (ADC) AS 200	2 Analog sensors AS 200
1 AC mains adapter 12 V / 300 mA	1 AC mains adapter 12 Volt / 300 mA
1 Optical fibres 1,5 m	1 Connecting cable 18 cm
Case 175 x 125 x 30 mm	2 Optical fibres 6 m
Accessories	Case 175 x 125 x 30 mm
Instruction	Asseccories
	Instruction
Technical data	Technical data

Other sensors to supplement the set are individually available on request.